Adaptive Dynamics Fault Range Rover How To Fix? However, the Brake, traction, and ride height control lights come on randomly and the hdc suspension lowering info displays on the instrument cluster. When I turn off. The height sensors feed information to both the ride level control module and dynamic control module. That means the sensors may not be your issue. The module could be. its normally the wires broken at the top of the suspension structs, even a LR technical bulletin issued showing replacement, but only needs wires re-joined in most.
Adaptive Dynamics Fault Range Rover is a common issue many owners of this model face. The fault is usually indicated by the “DSC Off” light coming on and the suspension feeling as though it has become stiffer than usual. This fault can be quite frustrating, however, it can be fixed relatively easily.
If you are having the Adaptive Dynamics Fault Range Rover issue, here are some steps you can take to try and fix it:
- First, check the battery voltage. This fault can be caused by a low battery voltage. If the battery is low, charge it and then start the engine and check the fault message is still present.
- Next, check the suspension level sensors. These are located at each wheel and should be checked for any damage or corrosion. If they are damaged, they will need to be replaced.
- Check the air suspension system. If the fault is present, the air suspension system will need to be checked for leaks or faults. If the system is found to be faulty, it will need to be repaired or replaced.
- Finally, check the adaptive dynamics control unit. This unit is responsible for controlling the suspension system and can be checked for any faults. If it is found to be faulty, it will need to be replaced.
If the fault message is still present after the above steps have been taken, then it is likely that the fault is caused by a faulty component in the suspension system. In this case, the suspension system will need to be inspected and any faulty components replaced.
It is important to note that if the fault is not fixed by these steps, it is best to take the car to a qualified mechanic to diagnose the issue and make any necessary repairs. Trying to fix the issue yourself can be dangerous and can cause further damage to the car.
In conclusion, the Adaptive Dynamics Fault Range Rover can be fixed relatively easily by following the steps outlined above. However, if the fault persists, it is best to take the car to a qualified mechanic to diagnose and repair any underlying issues.
Range Rover L322 2011 TDV8 Adaptive Dynamics Fault repair
Range Rover L322 Adaptive Dynamics Fault repair. Tools required: Soldering iron Solder Heatshrink Electrical tape T27 Torque bit/driver 20 mins Easy repair for a common fault. The wires in the engine bay can become brittle over time. I opted for some flexible reinforced wire to extend the wires to avoid pulling in the cable. The car tested fine after repair.