How To Adjust Harley Shocks Without Tool? How to Adjust the Rear Shocks on Your Harley Davidson Dyna Measure the Sag and Preload Adjust the Damping Settings Tweak the Compression Settings Adjust. I have put my 550 on the centerstand and used my hands to adjust the tension. I may have weak springs, but it happened. Steve Logged Steve_K 76 CB 550,. The way to adjust is first to loosen the upper ring and then screw down the lower and then bring down the upper until they touch? If all that is correct, what happens.
Harley shocks are an essential part of a motorcycle’s suspension system. They absorb bumps and shocks from the road and keep the bike steady and comfortable for the rider. Adjusting the shocks on your Harley is a relatively simple task that can be done without any tools, as long as you know the basics. Here are some tips on how to adjust Harley shocks without a tool.
The first step is to identify the type of shocks on your Harley. You may have traditional shocks that use coil springs, or you may have air shocks that use air pressure to provide suspension. Once you have identified the type of shocks you have, you can adjust them accordingly.
For traditional coil spring shocks, you will need to adjust the rear shocks first. This can be done by loosening the nut at the top of the shock and turning the adjuster clockwise to increase the stiffness of the shock, or counterclockwise to decrease it. Once the desired tension has been achieved, tighten the nut and repeat the process for the other side.
If you have air shocks, you will need to adjust the pressure in the shock. To do this, you will need to use a shock pump to add or remove air. Start by pumping the shock until it has reached the desired pressure, then check the pressure gauge to make sure it is correct. Once the correct pressure has been achieved, repeat the process for the other side.
Finally, once the shocks have been adjusted, it is important to check the ride height of the bike. This can be done by measuring from the ground to the bottom of the frame, and adjusting the shocks accordingly. If the ride height is too low, you will need to increase the tension on the shocks, and if it is too high, you will need to decrease the tension.
Adjusting the shocks on your Harley without a tool is a relatively simple task that can be done in a few minutes. Just remember to identify the type of shocks you have, adjust the tension or pressure accordingly, and check the ride height to make sure it is correct. With these steps, you can have your Harley shocks adjusted and ready to go in no time.
Honda Pioneer Rear Shock Adjustment 101. No spanner wrench. Hondasxs Forum
How to video on changing load tension setting on rear shocks without using a spanner wrench tool. Hondasxs Forum.