How To Bypass Ignition Switch On Scooter? To bypass the ignition switch on your scooter, you’ll need to get some wire and a 3-wire ignition switch. First, disconnect your battery by unplugging the red. Make use of a lengthy wire. This method is the simplest and most straightforward method you can ever use to bypass the ignition switch. When we think. To bypass the ignition switch on a scooter, you will need to remove the seat and locate the wires leading to the ignition. Cut the wire leading from the battery to the. Removing the ignitions from Chinese scooter allows it's to be started and driven. Method requires only a couple minutes of time, a switch and limited tools including.
Knowing how to bypass the ignition switch on a scooter can come in handy if you need to get your scooter started in an emergency. While it is not recommended to bypass the ignition switch, it is possible to do so, and here is how you can do it.
Step 1: Identify the wires connected to the ignition switch. The wires that are connected to the ignition switch are usually the same color, but different in size. Identify the two wires, and make sure that they are not connected to any other parts on the scooter.
Step 2: Cut the wire that is connected to the ignition switch. Cut the wire as close to the switch as possible, so that you can easily connect the two ends again if needed.
Step 3: Connect the two ends of the wire. Use some electrical tape to secure the connection. Make sure the connection is secure and will not come undone.
Step 4: Try to start the scooter. If the scooter starts, then you have successfully bypassed the ignition switch. If not, check the connection and make sure that it is secure.
It is possible to bypass the ignition switch on a scooter, but it is not recommended. If you do decide to do it, make sure that you understand the process and that you take the necessary precautions. Bypassing the ignition switch can be dangerous and should only be done in an emergency situation.
how to bypass a scooter ignition
Removing the ignitions from Chinese scooter allows it's to be started and driven. Method requires only a couple minutes of time, a switch and limited tools including a universal screwdriver to remove panels and quick releases. 8mm socket extended to remove ignition cylinder and locking stud. a pair 10mm bolts may be used instead of 8mm. The electrical wires were pre loosened to make for short video and requires a designated tool for clean…