How To Bypass Safety Switch On Zero Turn? Jun 3, 2019 / Bypass Seat Switch on Husqvarna Zero Turn. #6. In that case the brake switch is faulty. Parking brake switch is a double switch. One side switches 12. Check the wires and the connection. If all looks good, just replace the brake switch. If the switch is bad, you should be seeing the orange service light when the key. Give the spark plug wire a little tug to see if it’s loose. If it is, push it onto the plug and try starting the mower. If there isn’t any difference, remove the plug with a. Momentarily turn the ignition switch to the start position. The engine shouldn’t start with the PTO switch engaged. Start the mower and move both control levers fully.
Safety switches are important components on zero turn mowers. These switches protect the rider from injury by stopping the blades from spinning when the rider leaves the seat. However, there may be times when you need to bypass the safety switch in order to get the mower working again. Below are some simple steps to help you bypass the safety switch on a zero turn mower.
Step 1: Locate the safety switch. It is usually located in the seat or near the pedals. If the mower is new, check the manual to find out the exact location.
Step 2: Disconnect the electrical connection. On most mowers, the safety switch is connected to the battery via a connector. Unplug the connector and set it aside.
Step 3: Bypass the safety switch. To do this, you will need to use a jumper wire. Connect one end of the wire to the negative terminal of the battery and the other end to the positive terminal. This will bypass the safety switch and allow the mower to start.
Step 4: Test the mower. Start the mower to make sure it is working properly. If it starts and runs normally, the safety switch has been successfully bypassed.
Step 5: Reconnect the safety switch. Once you have verified that the mower is running properly, reconnect the electrical connection to the safety switch. This will ensure that the mower is safe to operate.
Bypassing the safety switch on a zero turn mower is not a difficult task. However, it is important to take the necessary precautions to ensure that the mower is safe to operate. Always make sure that the electrical connection is properly connected and that the safety switch is working properly before operating the mower.
How To Bypass Your Mower Seat Switch on a Zero-Turn Mower
Check out The Durbin Compound Merch Store now @ thedurbincompound.com/ I will try to ship within 24 hours from receiving your order so that you get what you order FAST! Thanks for the support everyone! This is a quick, down and dirty video about how to bypass your mower seat switch! This is something we all get aggravated with when we are out mowing. You want to pick up a stick or dog toy in the yard and well……you have to kill the…