How To Change Code On Spartan Mower? How do I change my pin code on a Spartan Zero Turn Mower? SLE Equipment 10.4K subscribers Subscribe 2.2K views 3 years ago In this video, you will. Spartan Mower Won’t Start There are various reasons this could happen, and it isn’t limited to Spartan mowers. This is very likely to happen if you have a dirty or. Spartan Mowers: Starting the mower & changing the code. Caldwell Equipment 455 subscribers 39K views 4 years ago . Show more Helping U online. If it was Me, I'd disconnect it all together, buy a regular ignition switch, choke and cable assembly, and blade engagement switch, you will need to wire it up.
Changing code on a Spartan mower is a relatively simple process that can be done at home. Spartan mowers are equipped with an electronic control unit, which is programmed with a code that controls the mower’s speed and safety features. Over time, this code can become out of date and need to be changed. To ensure that your Spartan mower is running at its best, it is important to keep the code up to date.
This article will provide step-by-step instructions on how to change the code on your Spartan mower. Before you begin, make sure you have the correct code for your mower, as this will be required for the process. You can find the code in the user manual that came with your mower.
Step-by-step Guide:
- Turn off the power to the mower. This can be done by either unplugging the power cord or turning off the breaker that supplies power to the mower.
- Open the control panel on the mower. This is usually located on the side of the mower frame.
- Locate the electronic control unit. This is usually a small rectangular box with a few wires connected to it.
- Remove the cover of the electronic control unit. This will expose the circuit board. Take note of the existing code on the board.
- Using a small screwdriver, remove the screws securing the circuit board to the electronic control unit.
- Lift the circuit board out of the unit. Take note of the existing code.
- Replace the existing code with the new code from the user manual. Make sure to enter the code correctly and double check it before securing the board back into the unit.
- Replace the screws to secure the circuit board back into the unit.
- Replace the cover of the electronic control unit.
- Turn on the power to the mower.
Once you have followed the steps outlined above, you have successfully changed the code on your Spartan mower. It is important to keep the code up to date in order to ensure that the mower is running at its best and all safety features are working correctly. If you have any questions or are having difficulty changing the code, contact a qualified technician to assist you.
Spartan Mowers: Starting the mower & changing the code.
.