How To Install Vinyl Lattice Cap Moulding? Lattice Cap and Divider Molding, creates a finish look for lattice. Both are available in a variety of colors to coordinate with any of our vinyl lattice. The cap and molding are. every two feet through both the moulding and lattice. Fasten with screws, taking care not to over-tighten. Along the sides and bottom, predrill oversized holes every two feet through.
Vinyl lattice cap moulding is an attractive and convenient way to cover the edges of lattice panels. It provides a neat, finished look and can be used to conceal irregular cuts or gaps. Installing a vinyl lattice cap moulding is a straightforward process that can be accomplished in just a few steps.
The first step is to measure the length of the lattice panels where the moulding will be installed. Measure from the outside edge of the panel to the inside edge of the panel, and then add two extra inches for the width of the moulding. This will give you the total length of the moulding pieces that you will need for the installation.
Once you have the length of the moulding pieces, you can begin to cut the pieces to the correct size. Use a measuring tape to mark the pieces and then use a hand saw or power saw to cut them. Be sure to use safety glasses when cutting the moulding pieces and wear a dust mask if you are using a power saw.
Once the moulding pieces are cut to the correct size, you can begin to install them. Start at one end and use a nail gun to attach the moulding pieces to the lattice panel. Make sure the nails are long enough to penetrate both the moulding and the lattice panel. Make sure the moulding pieces are evenly spaced and the nails are driven straight into the lattice panel. Continue until you have attached all of the moulding pieces to the lattice panel.
Once the moulding pieces have been attached, you can apply a coat of paint or stain to the moulding. This will help protect the moulding and give it an even, finished look. Be sure to use a paint or stain that is specifically made for use on vinyl products.
Finally, you can use a caulk gun to apply a bead of caulk along the inside edge of the moulding. This will help seal the moulding and ensure that the edges are sealed tightly. Allow the caulk to dry completely before installing the lattice panel.
Installing a vinyl lattice cap moulding is a simple process that can be done in just a few steps. Take the time to measure and cut the moulding correctly, and be sure to use a nail gun, paint or stain, and caulk to ensure a neat and professional-looking finish. With these tips, you can easily install a vinyl lattice cap moulding and give your lattice panel a finished look.