How To Light Ao Smith Water Heater? Whether you have a newly installed AO Smith Gas water heater or an older one, you must light up the pilot first. Otherwise, the status light won’t blink. Go along with. Common solutions for: AO Smith Water heater not lighting 01 – AO Smith Water Heater Igniter Some water heaters use an igniter to ignite the gas. If the igniter fails, the burner. How To Relight Your AO Smith Water Heater Once you have completed your cleaning and repairs, you can relight your AO Smith water heater by following these. You will be able to light the fire easier if you allow the fuel to escape. Step 1: To take the access panel off the A.O. SMITH water heater, you must first remove To the cover of the.
Lighting an AO Smith water heater is a straightforward process. It should take no more than a few minutes and doesn’t require any special tools or expertise. This guide will walk you through the steps you need to take to light your AO Smith water heater.
First, you will need to locate the pilot light. This is usually found on the side of the water heater, near the bottom. It should be clearly labeled and there should be instructions printed on the side of the unit. If not, consult your owner’s manual.
Next, you will need to turn off the gas supply. To do this, you will need to shut off the valve that supplies gas to the water heater. This is usually located on the side of the water heater, near the top. It should be clearly labeled and there should be instructions printed on the side of the unit. If not, consult your owner’s manual.
Once the gas supply has been shut off, you can now prepare to light the pilot light. To do this, you will need to locate the pilot light knob. This should be located on the side of the water heater, near the bottom. It should be clearly labeled and there should be instructions printed on the side of the unit. If not, consult your owner’s manual.
Once you have located the pilot light knob, you will need to turn it to the “on” position. This will allow gas to flow to the pilot light. Once you have done this, you will need to press the red ignition button. This should be located on the side of the water heater, near the bottom. It should be clearly labeled and there should be instructions printed on the side of the unit. If not, consult your owner’s manual.
If the pilot light is lit, you can now turn the gas supply back on. To do this, you will need to open the valve that supplies gas to the water heater. This is usually located on the side of the water heater, near the top. It should be clearly labeled and there should be instructions printed on the side of the unit. If not, consult your owner’s manual.
Finally, you will need to make sure that the pilot light is burning properly. To do this, you will need to look at the flame. It should be blue and steady. If it is flickering or yellow, you may need to adjust the pilot light knob. This should be located on the side of the water heater, near the bottom. It should be clearly labeled and there should be instructions printed on the side of the unit. If not, consult your owner’s manual.
Once you have completed these steps, you have successfully lit your AO Smith water heater. This is a relatively simple process that should take no more than a few minutes. If you have any questions or concerns, consult your owner’s manual or contact an AO Smith service technician.
How To Light AO Smith Water Heater With Honeywell Gas Valve
This video will show you how to light your AO Smith water heater with a Honeywell gas Valve. If your pilot light is out on your AO Smith water heater with the Honeywell gas valve chances are the wind blew it out. This video is for the AO Smith with the Honeywell Gas Valve. The Honeywell gas valve will show an error code to show the problem with the water heater. I have other videos that will show you how to light water heaters with…