How To Measure Drum Tension Rods? At least 3 sizes of tension rods that I've seen. The 'standard' size found on most drum kits. The 'fine pitch' that has a narrower gauge [DW, etc] The 'fat rods' with a. Gibraltar makes two different sized bass drum tension rods. 6mm for some older Japanese bass drums and the usual 7/32 rods. I'm not sure if 6mm rods will turn. Set a tension rod in place without screwing it in. Measure the distance between the hoop and the flange of the tension rod. The length of the tension rod,.
Drum tension rods are an integral part of any drum set, and it is important to make sure that they are tensioned correctly. If the tension rods are not tensioned correctly, it can affect the sound of the drums as well as the playing experience. Fortunately, measuring drum tension rods is a relatively simple process that does not require any specialized tools. Here is how to measure drum tension rods.
First, you will need to locate the tension rods on your drum set. They are located on the outside of the drum head, and should be easy to spot. Once you have located the tension rods, you will need to remove them from the drum head. To do this, you will need to loosen the tension rods until they can be unscrewed from the drum head.
Next, you will need to measure the tension rods. To do this, you can use a ruler or a caliper. You will need to measure the length of the rod from the end of the rod to the head of the drum. This measurement should be taken in millimeters. It is important to make sure that you are measuring the tension rod at the exact same location on both the top and bottom of the rod.
Once you have the measurements for the tension rods, you will need to compare them to the manufacturer’s specifications. Different drum sets will have different tension rod requirements, so it is important to look up the manufacturer’s specifications for the exact type of drum set you have. Once you have the manufacturer’s specifications, you can then compare the measurements you took to the manufacturer’s specifications to determine if the tension rod is correct or needs to be adjusted.
If the tension rod needs to be adjusted, you will need to tighten or loosen it depending on the measurements. To do this, you will need to use a drum key. Place the drum key on the tension rod and turn it clockwise to tighten the rod or counterclockwise to loosen it. You may need to make a few adjustments until you get the desired tension of the rod.
Finally, once the tension rod is set, you will need to re-install it onto the drum head. To do this, you will need to place the tension rod back into the lug and then tighten it until it is secure. It is important to not overtighten the rod, as this can cause damage to the drum head.
Measuring drum tension rods is an important step in setting up a drum set and making sure that it is tuned correctly. By following the steps outlined above, you can easily measure your drum tension rods and make sure that they are set to the correct tension.
Do THIS to Make Your Drums Easier to Tune!
Tuning drums can be tricky enough, so let’s make it as easy as possible. These two cheap, simple tasks will greatly improve the ease of tuning on your drums, and they will help your drums stay in tune longer. My personal preferred way to tune drums is to finger tighten the rods as far as I can go, then begin using a drum key to finish. The easier and smoother the finger tuning, the more likely I can quickly get the drum in tune with itself…
You can remove the heads and measure the distance from the bearing edge to the first lug screw and see that they were different based on the size of the drum in.