How To Replace Abs Wheel Speed Sensor Wire Harness Impala? Wheel speed sensor wire replacement 2014 Impala Limited DIY with Dave 2.13K subscribers Subscribe 6.1K views 2 years ago This video shows how I replaced a. How to Replace ABS Sensor Wire Harness 2006-2013 Chevrolet Impala – YouTube 0:00 / 8:50 How to Replace ABS Sensor Wire Harness 2006-2013 Chevrolet. Dorman ABS Wheel Speed Sensor Wire Harness 970-041 Part # 970-041 SKU # 64295 Limited-Lifetime Warranty Check if this fits your Chevrolet Impala Check if this fits your.
Replacing the ABS wheel speed sensor wire harness on your Impala can be a difficult and time-consuming task. But with the right tools and know-how, you can do it yourself and save time and money. Here is a step-by-step guide on how to replace the ABS wheel speed sensor wire harness on your Impala.
First, you’ll need to locate the ABS wheel speed sensor wire harness. This is usually located behind the dash on the driver’s side. You may need to remove some panels or trim pieces to access it. Make sure to disconnect the battery before you start, as this will prevent any electrical shock.
Once you have located the wire harness, you’ll need to remove it. To do this, you’ll need to remove the mounting bracket from the frame. You’ll also need to loosen the retaining screws and pull the wire harness out. If there are any other electrical components connected to the wire harness, you’ll need to disconnect them as well.
Next, you’ll need to install the new wire harness. Start by connecting the harness to the mounting bracket and then secure it in place with the retaining screws. Once the wire harness is in place, you’ll need to connect the other electrical components. Make sure the electrical components are connected tightly and securely.
Finally, you’ll need to test the new wire harness. Start the engine and check the ABS light. If it turns on, then the new wire harness is working properly. If the ABS light does not turn on, then there may be a problem with the wiring or the connections. In this case, you’ll need to check all the connections and make sure they are secure.
Replacing the ABS wheel speed sensor wire harness on your Impala is a relatively simple task. With the right tools and know-how, you can do it yourself and save time and money. Follow the steps above and you’ll have your Impala’s ABS wheel speed sensor wire harness replaced in no time.
How to Replace ABS Sensor Wire Harness 2006-2013 Chevrolet Impala
Buy Now! New ABS Sensor Wire Harness from 1AAuto.com 1aau.to/ia/1ATRS00332 This video shows you how to install an ABS sensor wire harness on your 2006-2013 Chevrolet Impala. This process should be similar on the following vehicles: 2006 Chevrolet Impala 2007 Chevrolet Impala 2008 Chevrolet Impala 2009 Chevrolet Impala 2010 Chevrolet Impala 2011 Chevrolet Impala 2012 Chevrolet Impala 2013 Chevrolet Impala Tools you will need: • 19mm Socket …
Connect your AC voltmeter to the sensor leads. Spin the hub or wheel at about 1 revolution per second (approximately 5 MPH). Read the AC voltage produced by. TechSmart ABS Wheel Speed Sensor Wire Harness N15002. Part # N15002. SKU # 165737. Limited-Lifetime Warranty. Check if this fits your 2010 Chevrolet Impala. Notes:.