How To Reset Jbl Tune 225tws? JBL TUNE 225TWS Earbuds WHAT’S IN THE BOX HOW TO WEAR First time use power on & connect Pairing power off Manual Controls BUTTON COMMAND. How to Restart JBL TUNE 225TWS Without Deleting Connections? Put both Earbuds into the Charging Case to Disable them. Take out your Earbuds in order to Power On your.
Resetting your JBL Tune 225TWS wireless earphones can be a tricky process, but it is necessary in order to keep them running smoothly. This article will provide you with a step-by-step guide on how to reset your JBL Tune 225TWS earphones.
The first step is to turn off the earphones. To do this, press and hold the power button until the LED light turns off. Once the earphones are off, press and hold the power button and the volume up button simultaneously for 10 seconds. This will initiate the reset process.
The next step is to put the earphones into pairing mode. To do this, press and hold the power button and the volume down button simultaneously until the LED light on the earphones begins to flash. This indicates that it is in pairing mode.
Once the earphones are in pairing mode, you can connect them to your device. To do this, open the settings on your device, select the Bluetooth settings, and then select the JBL Tune 225TWS earphones from the list of available devices. Your device will then connect to the earphones.
The final step is to reset the earphones. To do this, press and hold the power button, the volume up button, and the volume down button simultaneously for 10 seconds. This will reset the earphones to their factory settings.
Resetting your JBL Tune 225TWS earphones is an easy process and should only take a few minutes. By following the steps outlined above, you can ensure that your earphones are always running at their best.
JBL TUNE225tws – FACTORY RESET (How to UNPAIR)
This video explains how to perform a FACTORY RESET on the JBL TUNE225tws truly wireless Bluetooth earbuds. When both earbuds are inside of the charging case, press and hold the button on the right earbud. Take a close look at the LED on the right earbud. After a couple of seconds it will briefly blink in blue. That is when the factory reset is complete and all devices have been unpaired from the earbuds.