How To Test A Snowmobile Stator

How To Test A Snowmobile Stator? In my case i was looking for 30 vac. You will have to test this when the sled is cold as well when the sled has been running for a while or when it starts to act up. The. To test the stator you have to test the resistance between the wires. Unplug all plugs from the harness and test the resistance from the green wire to. Before you start riping appart your sled to get to the stator plate I would do the simple things first. 1 new plugs if that dosent work. 2 test your plug caps if they are ok. How do you put a stator to the test? Perform the static stator testing first. Disconnect the regulator from the stator when the ignition switch is turned off. Insert one.

How To Test A Snowmobile Stator
surce: youtube.com

A snowmobile stator is a type of generator that helps to power the snowmobile. In order to ensure that the snowmobile is running correctly and efficiently, it is important to test the stator regularly. This article will explain how to test a snowmobile stator.

The first step is to ensure that the snowmobile is turned off and the engine is cool. It is important to ensure that no electricity is flowing through the wires when testing a stator.

The second step is to locate the stator. Depending on the type of snowmobile, the stator may be located in a few different places. It is usually found around the engine or the alternator, and is usually a flat, rectangular box. If the stator is not easily visible, consult the snowmobile’s manual for its exact location.

The third step is to remove the stator from the snowmobile. To do this, remove the screws or bolts that hold it in place and gently pull it out. Be careful not to damage any of the wires connected to the stator.

The fourth step is to inspect the stator for any visible signs of damage. Check the wire connections for any frayed wires or exposed copper. If there are signs of damage, the stator should be replaced.

The fifth step is to test the stator with a multimeter. Set the multimeter to the appropriate setting and connect the probes to the terminals on the stator. The multimeter should read between 100 and 400 ohms, depending on the type of snowmobile. If the reading is not within the correct range, the stator should be replaced.

The sixth step is to reinstall the stator. Carefully reconnect the wires, making sure that the connections are secure. If necessary, use electrical tape or other insulation to ensure that the connections are not exposed. Reattach the stator to the snowmobile and secure it with the screws or bolts.

The seventh and final step is to start the snowmobile and check for any signs of electrical issues. If the snowmobile starts without any issues, the stator is functioning correctly. If there is any issue, the stator should be tested again.

Testing a snowmobile stator is a relatively simple process that can help to ensure that the snowmobile is running correctly and efficiently. By following these steps, you can easily test the stator and identify any potential issues.

Testing a stator in a snowmobile Arctic cat

Visit my web site Outdoor-Electric.com for stator winding information. This is a quick how-to testing a stator in an Arctic Cat triple.

Try replacing the non-sparking spark plug with a new spark plug. 3. The next step is pretty much the same whether you saw no spark or a weak spark. You unplug the. first thing you need is a quality electrical multi meter. no cheap chit. next, find the main plug thats located a few inches off the mag, near the recoil. unplug it. on.

Leave a Comment