Ultima 65 Laminator How To Change Film? Learn how to replace and load standard film into the Ultima 65 Laminator, from threading the machine to proper roll placement. Skip to Content Skip to footer Buy a Large.
Changing film on an Ultima 65 Laminator is a relatively simple task which should take no more than a few minutes. It requires no special tools, but you do need to follow certain steps for success. This article will walk you through the steps of changing film on your Ultima 65 Laminator.
First, you need to ensure that the power to the laminator is off. Unplug the power cord from the wall or switch the power off at the breaker panel. There is no need to take the laminator apart to change the film.
Next, make sure you have the right film for your laminator. The Ultima 65 Laminator is designed to work with a variety of film sizes and types. The film size should match the size of your document to be laminated. The film should also be compatible with the laminator’s temperature range. Be sure to check the manufacturer’s guidelines before purchasing the film.
Now, you are ready to take off the old film. Open the laminator cover and locate the two film spools inside. Unscrew the two spools and remove the old film. Make sure to dispose of the old film properly.
To install the new film, you will need to unroll the new film and thread it through the laminator. Start by unrolling the film and cutting it to the right size. Then, thread one end of the film through the laminator’s rollers. Keep pulling the film until it is securely in place. Finally, thread the other end of the film through the laminator’s rollers.
Once the film is threaded through the laminator, you can start to reassemble the laminator. Replace the two film spools and make sure they are securely fastened. Then, close the laminator cover and plug the power cord back into the wall. Switch the power back on at the breaker panel.
Finally, you can test the new film. Place a document in the laminator and turn it on. If the laminator is running smoothly, then your new film is installed properly. If not, make sure the film is securely in place and try again. If you are still having problems, contact the manufacturer for further assistance.
Changing film on an Ultima 65 Laminator is a simple task that shouldn’t take more than a few minutes. Be sure to follow the correct steps to ensure a secure film installation. With the right film and a little patience, you should have no problem changing film on your Ultima 65 Laminator.
Loading the Laminator
GBC Ultima 65 Roll Laminator
How to Change the Rolls on the HeatSeal Ultima 65 Laminator MyBinding.com 33.2K subscribers Subscribe 130 Share 49K views 8 years ago For. There are a few ways to change the laminator film on Ultima 65: Step#01 – Use the Manual Feeder This is the easiest way to change the laminator film. Simply open the laminator.